Landscape irrigation with treated water
Sprinkler irrigation on recycled water.
Lawns, gardens and green belts are the easiest place to reuse treated sewage. We connect your STP outlet to a filtered, disinfected irrigation network that waters landscapes without fresh water.
- Water source
- Treated STP or ETP outlet
- Systems
- Sprinklers, drip, hose points
- Controls
- Timers and zone valves

Overview
Landscaping is the first use for treated water.
Societies, campuses, hotels and factories often use thousands of litres a day on gardens, while their STP outlet goes to the drain. Treated sewage that is filtered and disinfected is well suited to landscape irrigation, and using it at night or early morning keeps contact with people low.
We take the STP outlet through a polishing filter and disinfection, store it in a dedicated tank and pump it to sprinkler, drip or hose zones. Fine filtration protects sprinkler nozzles and drippers from clogging, and timers water each zone at the right time.
You probably need this if
- Your STP outlet goes to the drain while gardens use fresh water
- Large lawns, green belts or a campus landscape
- You want automated watering with less manual work
- Your consent asks you to reuse treated water
How it works
The treatment step by step.
- 1
Polishing
Pressure sand filter and, where needed, carbon filter after the STP.
- 2
Disinfection
Chlorine dosing or UV before storage.
- 3
Storage
Recycled water tank sized for one day of irrigation.
- 4
Pumping and filtration
Pump set with screen or disc filter to protect nozzles.
- 5
Distribution
Zone valves, sprinklers for lawns and drip lines for shrubs and trees.
- 6
Scheduling
Timer or controller to water each zone at off-peak hours.
Technology options
Irrigation options.
Pop-up sprinklers
For lawns and play areas, with spray or rotor heads.
Drip lines
For hedges, shrubs and trees, with minimal runoff.
Zone timers
Automatic watering at night or early morning.
What you get
Built to run day after day.
Fresh water saved
Every litre of treated water used outside is a litre not bought.
Safe practice
Disinfection, separate pipes and watering at low-traffic hours.
Low maintenance
Filters protect nozzles; flush valves keep lines clean.
From enquiry to handover
One team, start to finish.
We design, fabricate, install and maintain the plant, so there is one point of contact for performance.
- 01
Site survey
We visit, test the water or wastewater, measure the space and note power, access and discharge points.
- 02
Process design
Flow and load calculations, treatment train, layout drawing and a clear scope of supply.
- 03
Fabrication
Tanks, skids, panels and piping built and checked in our Pune workshop before dispatch.
- 04
Install and commission
Erection, wiring, seeding or start-up, trial runs and operator training at your site.
- 05
Operate and maintain
Optional operation, AMC visits, spares and performance reports so the plant keeps working.
Faster, more accurate quotes
What to share with your enquiry.
A few details let us size the plant properly the first time. If you do not have them yet, we can measure or test on site.
- STP capacity and outlet quality
- Landscape area and layout
- Current watering method and water source
- Preferred watering times
Questions we hear
Questions about sprinkler irrigation with treated waters.
Is it safe to irrigate gardens with treated sewage?
Yes, when the water is properly treated, filtered and disinfected, and watering is done at times when people are not on the lawn. It is one of the most common reuse routes.
Will treated water damage plants?
Well-treated water suits most landscape plants. Very high salt content can affect sensitive species, so we check TDS and advise.
Do sprinklers clog with recycled water?
Not with proper filtration. A sand filter after the STP and a screen or disc filter at the pump protect the nozzles.
Do you install agricultural irrigation?
Our focus is landscape irrigation using treated water from STPs and ETPs. For farm irrigation systems, ask us and we will point you to the right specialist.
Related systems
Often specified together.
Talk to an engineer
Planning a sprinkler irrigation with treated water?
Share your flow, water quality and site details. An engineer will reply with the next step, usually a site visit or a sizing call.