Upgrade and retrofit
Fix the plant you already have.
An overloaded or failing plant rarely needs to be demolished. We audit it, find what limits performance and upgrade those parts: biology, aeration, settling, filtration or controls.
- Typical gain
- More capacity in the same tanks
- Common upgrade
- Conversion to MBBR
- Downtime
- Planned to keep treatment going

Overview
Most failing plants have a few root causes.
Plants fail for predictable reasons: the building filled up faster than planned, blowers or diffusers wore out, sludge was not removed, or the original design was too small. Finding the real cause first avoids spending on the wrong fix.
Converting an activated sludge tank to MBBR by adding media is often the most effective upgrade, adding biological capacity in the same tank. Other common fixes are new blowers and diffusers, tube settlers in clarifiers, tertiary filters and better controls.
You probably need this if
- STP overloaded after full occupancy
- Treated water fails lab tests
- Plant smells or foams
- Tertiary treatment needed for reuse
How it works
The treatment step by step.
- 1
Audit
Flow measurement, sampling, equipment checks and record review.
- 2
Root cause
Report showing what limits the plant and what each fix achieves.
- 3
Upgrade design
Media, aeration, settling, filtration or control changes, with drawings.
- 4
Execution
Phased work to keep sewage treated during the upgrade.
- 5
Verification
Re-testing and handover with updated operating instructions.
Upgrade options
What we typically change.
MBBR conversion
Media and screens added to existing aeration tanks.
Aeration upgrade
Efficient blowers, fine bubble diffusers and DO-based control.
Settling and filtration
Tube settlers, pressure sand and carbon filters.
Automation
Panels with timers, level controls and remote alarms.
What you get
Built to run day after day.
Capacity without new tanks
More treatment from the existing civil structure.
Lower power
Efficient blowers and diffusers often pay back quickly.
Back in compliance
Treated water that passes tests again.
From enquiry to handover
One team, start to finish.
We design, fabricate, install and maintain the plant, so there is one point of contact for performance.
- 01
Site survey
We visit, test the water or wastewater, measure the space and note power, access and discharge points.
- 02
Process design
Flow and load calculations, treatment train, layout drawing and a clear scope of supply.
- 03
Fabrication
Tanks, skids, panels and piping built and checked in our Pune workshop before dispatch.
- 04
Install and commission
Erection, wiring, seeding or start-up, trial runs and operator training at your site.
- 05
Operate and maintain
Optional operation, AMC visits, spares and performance reports so the plant keeps working.
Faster, more accurate quotes
What to share with your enquiry.
A few details let us size the plant properly the first time. If you do not have them yet, we can measure or test on site.
- Plant capacity and process type
- Recent lab reports
- Photos of the plant
- Occupancy or production now versus design
Questions we hear
Questions about stp upgrade and retrofits.
Can an existing STP be converted to MBBR?
In most cases yes. Media and retention screens are added to the aeration tank, and aeration is checked and upgraded if needed.
Will the plant need to shut down?
We plan work in stages, often one tank at a time, so treatment continues.
How do we know the upgrade worked?
We test before and after, and the handover includes the results.
Is an upgrade cheaper than a new plant?
Usually, because the civil structure is reused. The audit shows the comparison clearly.
Related systems
Often specified together.
Talk to an engineer
Planning a stp upgrade and retrofit?
Share your flow, water quality and site details. An engineer will reply with the next step, usually a site visit or a sizing call.